Angle Iron Adapter 52x52x8mm

Adapter for knocking in Angle Iron posts.

Adapter internal dimensions are 52x52x8mm.
Suitable for 50x50x5mm posts.
For use on the Classic35 and Classic 50 models.

Use a 6mm hex key to unscrew the 8 bolts & locking washers. Slide the current tube off the base of the Post Driver. Slide the new Adapter into its place and attach using the same bolts and washers. Remember to use a Locking Compound on the screw threads to stop them vibrating out.

To get the most effective use from the Post Driver, the Adapter size must be a snug fit for your Posts. We recommend the Adapter must be no more than 5-10mm larger than your Post. For shaped posts; squares / t-shapes etc the outer corners need to be within this capacity.

If you are unsure what adapter are right for you, please contact us for advice specific for your application.

The maximum size post that can be driven in is 4” (100mm) diameter.Our largest adapter is 107mm internal diameter. When the ground is very dry, compacted or stony, you will need to make a pilot hole for posts larger than 78mm. This can be either by hand using a Pilot-Bar, or mechanically using the Pilot Core Tool. Posts smaller than 78mm should not need a pilot hole. Ground conditions of Clay or Chalk may also require this method.